SBRFrontButtonAndLED

From SqueezeboxWiki

SqueezeboxReceiver has one button with a TricolorLED behind it.

Button usage:

• To put SqueezeboxReceiver into setup mode, press and hold the button for about 3 seconds or until it blinks slow RED then release it.

• To do a factory reset on SqueezeboxReceiver, continue holding for a total of 6 seconds until it starts blinking fast RED. Release and after factory reset, it will start flashing slower and be ready to set up.

• If you press and hold the button while plugging in the Receiver, you'll see the button sequence through a series of colors and a set of ascending test tones will be played through the audio outputs.

• When connected to SqueezeCenter or SqueezeNetwork the button is WHITE, press to pause the music. Press again to start the music up again.

• While music plays the button is bright WHITE; when paused it is dark WHITE.

Color codes:

LED color	Meaning
RED (solid)	Booting up
RED (blinking slow)	Awaiting to be setup
YELLOW	Waiting for wireless to connect / Link down on ethernet
GREEN	Network connected, waiting for DHCP to get IP address (skipped when using static IP)
BLUE	Waiting to connect to SqueezeCenter or SqueezeNetwork
WHITE	Connected to SqueezeCenter or SqueezeNetwork
WHITE (blinking fast)	Firmware update in progress
RED (blinking fast)	Factory Reset and xilinx update in progress
PURPLE	Hard error with blink codes, a number of blinks with a one second pause in between

Hard error codes:

Number of blinks	Meaning
1 blink	MAC address missing/bad (checked second upon boot-up)
2 blinks	Wireless card missing/bad (checked first upon boot-up)
3 blinks	SNV failure/error
4 blinks	Upgrade error
5 blinks	CPLD XSVF file open error (xilinx file)
6 blinks	UUID not set/all zeros (Checked third upon boot-up)